K 2500 Truck 4WD V8-350 5.7L VIN K TBI (1995)
-
Line up the reference marks made previously.
2. Retainers and bolts.
TIGHTEN
-
Retainer bolts to 20 Nm (15 lb.ft).
3. Propeller shaft to transfer case.
-
Line up the reference marks made previously.
-
Adjust the propeller shaft length.
4. Retainers and bolts.
TIGHTEN
-
Retainer bolts to 20 Nm (15 lb.ft).
5. Skid plate (if applicable).
SLIP YOKE SPLINES
Apply chassis lubricant at the slip spline grease fitting until the grease begins to leave through the vent hole. If the slip spline is dry or corroded, it may
be necessary to disconnect the propeller shaft from the vehicle, remove the slip yoke, and wire brush the affected area. Wipe clean before installation.
Bulletin No.: 56-41-01
Fastener Tightening Specifications