K 2500 Truck 4WD V8-5.7L VIN R (1996)
3. Insert the inner race into the cage by rotating the inner race downward:
A. Hold the inner race at 90° to the centerline of the cage.
B. Align the lands of the inner race with the windows of the cage.
C. Insert the inner race into the cage, by rotating the inner race downward.
4. Insert the cage and inner race into the outer race.
5. Place a brass drift against the cage. Tap gently on the brass drift in order to tilt the cage. Install the first ball when the cage tilts. Tilt the cage in the
opposite direction. Install the second ball on the side opposite the first ball.
6. Repeat step 5 to reinstall all of the balls.
Reinstall CV Joint and Seal Onto Drive Axle
-
Required Tools:
-
J 35910 Seal Clamp Tool
-
J 36652 Swage Clamp Tool
-
J 36652-1 Split Plate Swage Clamp (K10/K20 models)
-
J 36652-2 Split Plate Swage Clamp (K30 models)
1. Pack the CV joint seal and the CV joint assembly with the grease supplied in the kit. The amount of grease supplied in this kit has been
pre-measured for this application.