K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
1. Apply a small amount of clean engine oil the crankshaft balancer,
2. Lightly tap the crankshaft balancer into the crankshaft.
3. Install the J23523-F to the crankshaft balancer.
4. Install the crankshaft balancer to the crankshaft.
5. Remove the J 23523-F from the crankshaft balancer.
IMPORTANT: When installing the crankshaft balancer bolt and washer, make sure take the curved part of the washer is pointed away from the
engine.
NOTICE: Refer to Fastener Notice in Service Precautions.
6. Install the crankshaft balancer bolt and washer to the crankshaft.
Tighten the bolt to 270 Nm (200 ft. lbs.).
7. Install the crankshaft pulley to the crankshaft.
8. Install the crankshaft pulley bolts.
Tighten the bolts to 40 Nm (30 ft. lbs.).
9. Install the lower fan shroud to the radiator.
10. Lower the vehicle.
11. Install the drive belt in the vehicle.
