Lumina V6-191 3.1L (1990)
Figure 1
Figure 1
Remove or Disconnect
1.
Air cleaner assembly, if necessary to access battery cables.
2.
Negative battery cable.
3.
Left side sound insulator panel.
-
Slide steering shaft protective sleeve towards the cowl.
4.
Air distribution tube and pull down.
5.
Retainer clip which holds stoplamp switch to steering column bracket.
6.
Switch arm from pedal by pushing the arm over and off of the brake pedal pin.
-
Release switch by pulling down and releasing top snap clip.
7.
Connector position assurance (CPA) locking pins from the four wire and two wire connector.
8.
Two wire connector.
-
Two wire connector is optional cruise control equipment.
9.
Four wire connector.
10.
Switch
Install or Connect
1.
Two wire connector and CPA, if equipped with cruise control.
2.
Switch
-
Make sure brake switch is NOT adjusted (metal clip on actuator not engaged with serrations on bottom of carrier).
