Lumina V6-3.1L VIN J (2000)
Hazard Warning Flasher: Service and Repair
REMOVAL PROCEDURE
1. Remove the LH instrument panel (IP) insulator.
2. Pull the hazard/turn signal flasher (2) to release the flasher retainer from the dash mat (1).
3. Disconnect the electrical connector from the flasher.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the hazard/turn signal flasher.
2. Align the flasher (2) to the dash mat (1), then press the flasher into place to secure.
3. Install the LH IP insulator.