Lumina V6-3.1L VIN J (2000)
5. Remove the trim cover tether mounting fasteners (3).
6. Remove the trim cover tether (1) from the inflatable restraint IP module (4).
IMPORTANT: If the inflatable restraint IP module mounting holes or fasteners are damaged to the extent that the module can no longer be properly
mounted, use the following repair. Torque the replacement fastener with a hand tool in order to prevent stripping the replacement fastener.
1. Remove the stripped fastener and discard it.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the inflatable restraint IP module (1) to the cross-car beam (2) with new fastener (3) GM P/N 25601790.
Tighten
Tighten fastener to 7 N.m (62 lb in).
INSTALLATION PROCEDURE
1. Install the trim cover tether (1) to the inflatable restraint IP module (4).
NOTE: Refer to Fastener Notice in Service Precautions.