Lumina APV V6-191 3.1L (1990)
terminal "B" (RED/WHT wire) (Figure 1).
Rear height motor will begin to operate in the UP direction with jumper wires connected. Allow motor to operate until rear of seat is in the full UP
position.
10.
Both jumper wires (C and D) from both connectors (A and B).
11.
Separate two-way connector C304 (B) (Figure 2).
12.
Using a thin 8" flat blade screwdriver, carefully reach under driver's seat and disconnect driver's seat adjuster switch connector (E) from driver's
seat adjuster switch (1001) (Figure 2).
13.
Using same 8" flat-bladed screwdriver, release locking tabs and remove driver's seat adjuster switch (1001) from adjuster cover (1006) (Figure 2).
Install or Connect
1.
Driver's seat adjuster switch (1001) to adjuster cover (1006) (Figure 2). (Both the switch and the cover are indexed to prevent improper
installation.)
2.
Connector (E) to driver's seat adjuster switch (1001) (Figure 2).
3.
Six-way connector (A) under driver's seat.
4.
Two-way connector C304 (B) under driver's seat.
WARRANTY INFORMATION:
Labor Operation: N2411
Use applicable labor time guide for labor hours.
