Lumina APV V6-191 3.1L VIN D TBI (1995)
6. Module attaching screws, and lift module from housing.
note: Do not wipe grease from module, or distributor base, if same module is to be replaced.
INSTALL OR CONNECT
NOTE: If a new module is to be installed, a package of silicone grease will be included with it. Spread the grease on the metal face of the module
and on the distributor base where the module seats. This grease is necessary for module cooling.
1. Module onto housing.
2. Module screws.
3. Electrical connectors to module.
4. Rotor and screws.
5. Cap by simultaneously depressing and rotating screws clockwise 180 degrees.
6. Air cleaner assembly.