Lumina APV V6-3800 3.8L (1994)
2.
Grasp retractor side belt webbing and attempt to pull out additional webbing from retractor by sharply tugging on belt webbing.
3.
Repeat steps 1 and 2 three (3) times, buckling and unbuckling belt each time.
4.
If additional webbing can be extracted from retractor during any of the three attempts, replace retractor assembly with a new retractor assembly
(steps 5-10).
If additional webbing cannot be extracted from retractor during any of the three attempts, no further action is required. Proceed to step 12.
5.
Remove affected seat from vehicle.
6.
Remove retaining screw and seat side cover.
7.
Remove retaining bolt and seat belt retractor.
8.
Install new retractor with retaining bolt. Torque bolt to 42 N-m (31 lb.ft.).
9.
Install seat side cover and secure with retaining screw.
10.
Reinstall seat.
11.
Repeat steps 1 thru 3 to assure that retractor operates correctly and make any corrections as required.
12.
Install Campaign Identification Label.
Campaign Identification Label
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit - dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner. Additional "Campaign Identification Labels" can be obtained from DAC.
Apply "Campaign Identification Label" only on a clean, dry surface.
Claim Information
