Malibu L4-144 2.4L DOHC VIN T SFI (1998)
Fluid Pressure Sensor/Switch: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Remove the transmission case side cover.
3. Remove the pressure switch assembly (13) (6 bolts).
INSTALLATION PROCEDURE
IMPORTANT: Inspect the O-rings for the pressure switch assembly for any damage.
1. Install the pressure switch assembly (13). Make sure all O-rings are in place.
2. Torque the 6 bolts holding the pressure switch assembly to 12 Nm (9 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the transmission case side cover.
4. Connect the negative battery cable.
5. Fill the transmission with fluid to the proper level. Refer to Transmission Fluid Checking Procedure (Oil Level Check).