Malibu L4-144 2.4L DOHC VIN T SFI (1998)
18.
Using a small "pick" like tool, remove the bearing retainer from the bearing. Refer to Figure 4.
19.
After removing the bearing retainer, reposition the ball bearings into two groups of four. Refer to Figure 5
20.
Separate the 2-legged puller from the center nut on the J 44714-B and insert the puller legs into the openings between the two groups of ball
bearings.
21.
With the forcing screw back off, screw the center nut into the puller and tighten until the nut bottoms against the puller. Refer to Figure 6.