Malibu L4-2.4L (2010)
2. Do the following from outside the vehicle and through the opening of the sunroof window from the right or left side.
1. Install the guide tab (1) into left front corner.
2. Rotor the sunshade until the guide tab (2) is insert into the right corner.
3. Insert the sunshade guide tab (3) flex the sunshade panel as needed to seat.
4. Arch the sunshade in the rear right corner (4) until guide tab can be installed.
5. Carefully flex the rear of the sunshade under water drain channel to allow the sunshade guide tabs (5) and (6) to clear.
3. While seated inside the vehicle with the sunshade in the closed position, verify that the front of the sunroof is not bent upward. If the sunshade is
bent, grab the front middle of the sunshade and carefully pull down to adjust the shade to fit the front center edge.
4. Install the sunroof window panel. Refer to Sunroof Window Replacement (See: Sunroof / Moonroof Panel/Service and Repair).
