Malibu L4-2.4L (2010)
Installation Procedure
1. Position the sunroof motor to the sunroof module.
2. Push the sunroof motor straight upward to engage the drive gear between the cables housed within the sunroof cable drive tubes.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the sunroof actuator screws to the sunroof actuator and tighten the screws to 4 Nm (35 lb in).
4. Connect the electrical connector to the sunroof motor.
5. Install the headliner. Refer to Headlining Trim Panel Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair).
6. Initialize/teach the sunroof motor. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for
programming and setup information.
7. Inspect the sunroof for proper operation.