Malibu L4-2.4L (2010)
Caution: Do not damage the cylinder block surface. Damage to the cylinder block surface can cause engine failure.
12. Remove EN 45680-881 fixture, EN 45680-882 cylinder bore sleeve puller, and the cylinder bore sleeve from the engine block.
13. Inspect the cylinder bore in the cylinder block for cracks or damage. If cracked or damaged, replace the cylinder block.
Installation Procedure
Caution: Do not use assembly aids or lubricants on the cylinder bore sleeve or the cylinder bore block when installing a new cylinder bore sleeve,
or engine damage will occur. These items will not aid in the installation of the new cylinder bore sleeve.
Caution: Do not chill or heat the cylinder bore sleeve or the cylinder block when removing or installing a new cylinder bore sleeve. Chilling or
heating the cylinder bore sleeve or the cylinder block will cause engine damage and will not aid the removal or installation of the new cylinder
bore sleeve.
1. Place the NEW cylinder bore sleeve onto the cylinder block.
2. Install EN 45680-881 fixture and EN 45680-883 cylinder bore sleeve installer assembly over the cylinder bore sleeve and onto the cylinder block.
Do not apply downward pressure to the cylinder bore sleeve.
