Malibu L4-2.4L (2010)
2. Place the container on a level surface for approximately 5 minutes in order to allow settling of the particulate contamination. Particulate
contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as
black and irregular particles.
3. Observe the fuel sample. If any physical contaminants or water are present, clean the fuel system.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
Fuel System Cleaning (See: Service and Repair)
