Malibu L4-2.4L (2010)
1. Clean the area around the mounting point for the tire pressure sensor.
2. Install the washer (2) and the seal (3) on the tire pressure sensor (1).
3. Install the tire pressure sensor (1) on the wheel.
4. Start the nut (4) by hand.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: When installing the tire pressure sensor and the nut, position the tire pressure sensor so that it is parallel to the inside wheel surface while
torquing.
5. Install the nut (2) on the tire pressure sensor (1).
Tighten the nut (2) to 7 Nm (62 lb in).
6. Install the tire on the wheel. Refer to Tire Dismounting and Mounting (See: Tires/Service and Repair/Removal and Replacement).
7. Install the tire/wheel assembly on the vehicle. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
8. Lower the vehicle.
