Malibu L4-2.4L (2010)
4. Install the transmission mount to bracket upper nut. Hand tighten only.
Caution: Refer to Fastener Caution
5. Tighten the transmission mount nut and bolts.
*
Tighten the transmission mount upper nuts to 50 Nm (37 lb ft).
*
Tighten the transmission mount lower bolts to 50 Nm (37 lb ft).
6. Install the left splash shield.
7. Install the left front tire and wheel.
8. Lower the vehicle.
Transmission Rear Mount Replacement
Transmission Rear Mount Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Remove the left tire and wheel.
3. Using a suitable jack stand, support the rear of the powertrain.