Malibu L4-2.4L (2010)
Constant Velocity Joint: Testing and Inspection
Wheel Drive Shaft Inner Joint Inspection
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
1. Remove the wheel drive boot clamp (2) from the tripod housing (3).
2. Remove the wheel drive shaft tripod housing (3) from the wheel drive shaft.
3. Remove the wheel drive shaft tripod joint boot bushing (1).
4. Using a suitable cleaner, remove the excess grease from the tripod assembly.
5. Inspect the following items for damage or excessive wear:
*
The wheel drive shaft tripod boot
*
The wheel drive shaft tripod assembly
*
The wheel drive shaft tripod joint housing
*
The wheel drive shaft tripod joint bushing
*
The wheel drive shaft
6. If any of the internal parts are found to be excessively worn or damaged, replace the wheel drive shaft inner joint and boot. Refer to Wheel Drive
Shaft Inner Joint and Boot Replacement (See: Service and Repair/Wheel Drive Shaft Inner Joint and Boot Replacement).