Malibu L4-2.4L Hybrid (2008)
Transmission Position Switch/Sensor: Service and Repair
6T40/6T45 - Automatic Transmission
Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement
Special Tools
*
J 23129 Universal Seal Remover
*
J 6125-B Slide Hammer
*
J 41229 Manual Shaft Pin Installer
Removal Procedure
1. Remove the control valve body. Refer to Control Valve Body Replacement (See: Automatic Transmission/Transaxle/Valve Body/Service and
Repair/6T40/6T45 - Automatic Transmission/Control Valve Body Replacement) .
2. Remove the manual shaft detent lever hub pin (1).
3. Remove the manual shift shaft pin (5) using J 23129 and J 6125-B . Discard the pin.
4. Remove the manual shaft (2).
5. Remove the manual shaft detent (w/shift position switch) lever assembly (4).
Installation Procedure
