Malibu V6-3.1L VIN J (2002)
1. Install the pressure hose (4) to the vehicle.
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the pressure hose (4) to the power steering gear (5).
^
Tighten the fitting to 27 Nm (20 ft. lbs.).
3. Install the pressure hose (4) to the retainer (6).
4. Lower the vehicle.
5. Install the pressure hose (4) to the power steering pump (1).
^
Tighten the fitting to 27 Nm (20 ft. lbs.).
6. Install the power steering hose retainer nut (1) to the retainer (2).
^
Tighten the retainer nut to 5 Nm (45 inch lbs.).
7. Ensure that the power steering hose has sufficient clearance from the exhaust manifold.
8. Install the drive belt to the power steering pump pulley.
9. Bleed the air from the power steering system.
