Malibu V6-3.5L VIN 8 (2004)
Control Module HVAC: Service and Repair
HVAC System - Automatic
Blower Motor Control Processor Replacement
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right closeout panel.
2. Remove the blower motor control processor wire harness connector.
3. Remove the blower motor control processor screws.
4. Remove the blower motor control processor.
INSTALLATION PROCEDURE
1. Install the blower motor control processor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Tighten the blower motor control processor screws.
Tighten
Tighten the blower motor resistor screws to 1.5 N.m (13 lb in).
3. Install the blower motor control processor wire harness connector.
4. Install the right closeout panel.
HVAC Control Module Replacement
