Malibu V6-3.9L (2007)
1. Install the communication interface module.
Notice: Refer to Fastener Notice.
2. Tighten the communication interface module bolts.
Tighten the bolts to 10 N.m (89 lb in).
3. Connect the communication interface module wire harness and antenna connectors.
4. Install the right closeout panel.
Important: After replacing the communication interface module, you must reconfigure the OnStar system. Failure to reconfigure the
system will result in an additional customer visit or repair. In addition, pressing and holding the white dot button on the keypad will NOT
reset the OnStar system. This action will cause a DTC to set.
5. Reconfigure the OnStar system. Refer to Control Module References.
