Malibu Classic L4-2.2L (2008)
Installation Procedure
1. Install the hood latch release cable to the hood latch.
2. Position the hood latch to the alignment marks on the support bracket.
Notice: Refer to Fastener Notice.
3. Install the hood latch bolts.
4. Tighten the latch bolts with the latch in the full up position.
5. Connect the remote start electrical connector, if equipped.
6. Slowly close the hood and press down until the hood is flush with the fenders.
7. Open the hood.
Tighten the bolts to 10 N.m (89 lb in).
8. Adjust the hood, if required. Refer to Hood Adjustment.
9. Install the fascia support.
10. Close the hood.
