Malibu Classic L4-2.2L (2008)
Brake Pedal Assy: Service and Repair
Brake Pedal Assembly Replacement
Removal Procedure
1. Remove the knee bolster.
2. Remove the closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.
3. Remove the electrical connector from the brake apply sensor.
4. Remove the steering column assembly from the vehicle. Refer to Steering Column Replacement (Electronic Power Steering (EPS)), (Hydraulic
Power Steering (HPS)).
5. Disconnect the brake pedal pushrod retaining clip (1) the wave washers (2) and the brake booster pushrod (3) from the brake pedal pin (4).
6. Remove the 2 brake pedal assembly to cowl mounting nuts.
