Malibu Classic L4-2.2L (2008)
4. Install the park brake cable to the caliper.
5. Remove the caps or plugs from the brake caliper opening and the brake hose.
Important: DO NOT reuse the copper brake hose gaskets.
6. Install NEW copper brake hose gaskets to the brake hose-to-caliper bolt and to the brake hose.
7. Install the brake hose and the brake hose-to-caliper bolt to the brake caliper.
Tighten the brake caliper bolt to 50 N.m (37 lb ft).
8. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual), (Pressure).
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 11 and 12 until a firm brake pedal apply is obtained; this will properly seat the brake caliper pistons and brake
pads.
12. Install the tire and wheel assembly.
13. Lower the vehicle.
14. Apply and release the park brake pedal 4 times.
Brake Caliper Bracket Replacement - Front
Brake Caliper Bracket Replacement - Front
Removal Procedure
Caution: Refer to Brake Dust Caution.
