Malibu Classic L4-2.2L (2008)
7. Remove the brake hose-to-wheel cylinder bolt from the wheel cylinder.
8. Remove the brake hose from the wheel cylinder.
9. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the wheel cylinder and/or the brake hose end.
10. Cap or plug the opening in the wheel cylinder and the brake hose to prevent fluid loss and contamination.
Installation Procedure
Important: Install the NEW copper brake hose gaskets.
1. Remove the caps or plugs from the opening in the wheel cylinder and the brake hose.
2. Install 2 new copper gaskets, the brake hose and the brake hose bolt to the wheel cylinder.
Notice: Refer to Fastener Notice.
Tighten the brake hose bolt to 50 N.m (37 lb ft).
