Malibu Classic L4-2.2L (2008)
Exhaust Pipe: Service and Repair
Exhaust Manifold Pipe Replacement (L61)
Tools Required
J 39194 Oxygen Sensor Wrench
Removal Procedure
Notice: The use of excessive force may damage the threads in the exhaust manifold/pipe.
Important: The in-line connector and louvered end must be kept clear of grease, dirt or other contaminants. Avoid using cleaning solvents of
any type. DO NOT drop or roughly handle the HO2S.
Important: The HO2S may be difficult to remove when the engine temperature is less than 48°C (120°F)
1. Raise and support the vehicle. Refer Lifting and Jacking the Vehicle.
2. Remove the connector position assurance (CPA) retainer (1).
3. Disconnect the heated oxygen sensor (HO2S) electrical connector (2).
