Malibu Classic L4-2.2L (2008)
4. Remove the mode actuator screws.
5. Remove the mode actuator.
Installation Procedure
1. Install the mode actuator.
Notice: Refer to Fastener Notice.
2. Install the mode actuator screws.
Tighten the screws to 1.5 N.m (13 lb in).
3. Install the mode actuator wire harness connector.
4. Close I/P compartment door. Refer to Instrument Panel Compartment Replacement.
5. Install the fuse labeled HVAC CTRL (BATT).
Recirculation Actuator Replacement
Recirculation Actuator Replacement
Removal Procedure