Malibu Classic L4-2.2L (2008)
1. Install the bulbs to the tail lamp, stop lamp, and/or backup lamp sockets.
2. Install the tail lamp, stop lamp, and/or backup lamp sockets to the tail lamp. Rotate the sockets clockwise until the sockets are fully seated.
3. Connect the electrical connector to the tail lamp wiring harness.
4. Position the tail lamp to the quarter panel. Ensure that the 2 locating pins are seated.
Notice: Refer to Fastener Notice.
5. Install the tail lamp screws to the tail lamp.
Tighten the tail lamp screw to 2 N.m (18 lb in).
6. Close the liftgate.
