Malibu Classic L4-2.2L (2008)
1. Position the spring on the lower control arm.
2. Use the jack stand to raise the lower control arm into position.
Notice: Refer to Fastener Notice.
3. Install the lower control arm to knuckle bolt, nut, and inboard fastener.
Tighten the bolt and nut to 60 N.m (44 lb ft) plus an additional 60 degrees.
4. Remove the OTC 204-167 or equivalent on vehicle spring compressor to compress the coil spring.
5. Remove the jack stand.
6. Install the rear tire and wheel.
7. Lower the vehicle.
Coil Spring Insulators Replacement
Coil Spring Insulators Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
