Malibu Classic L4-2.2L (2008)
Extension Housing: Service and Repair
Case Extension Housing Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the right drive axle from the transaxle.
4. Remove the transaxle brace.
5. Remove the vehicle speed sensor.
6. Remove the case extension housing bolts (5).
7. Remove the case extension housing (6) with the axle seal and the O-ring (8).
Installation Procedure
1. Install the O-ring (8) to the case extension housing (6).
2. Install the case extension housing (6) with the axle seal and the O-ring (8).
Notice: Refer to Fastener Notice.
3. Install the case extension housing bolts (5).
Tighten the bolts to 36 N.m (27 lb ft).
4. Install the vehicle speed sensor.
5. Install the transaxle brace.
6. Install the right drive axle to the transaxle.
7. Lower the vehicle.
8. Connect the negative battery cable.
Notice: Refer to Transmission Overfill Notice.
9. Check and fill the transaxle as necessary.
10. Inspect for fluid leaks.