Malibu Classic L4-2.2L (2008)
Parking Lock Cable: Service and Repair
4T65-E - Automatic Transaxle
Park Lock Cable Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Remove the console.
3. Remove the left sound insulator.
4. Remove the knee bolster.
5. Place the transmission shift lever in the P (Park) position.
Important: Do not proceed to the next step with the key in any other position.
6. Turn the ignition key to the RUN position.
7. Insert a screwdriver blade into the slot provided in the ignition switch inhibitor.
8. Depress the cable latch. Pull the control cable from the inhibitor.
9. Push the cable connector lock button at the shifter base to the up position.
10. Snap the cable from the park/lock lever pin.
11. Depress the two cable latches. Remove the control cable from the transmission control.
Installation Procedure