Metro L3-061 1.0L VIN 6 TBI (1998)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement (Front)
REMOVAL PROCEDURE
1. Disconnect the Negative (-) battery cable.
2. Raise and suitably support the vehicle.
3. Remove the Front wheel.
4. Disconnect the front wheel speed sensor electrical connector.
5. Remove the retaining bolt.
6. Remove the front wheel speed sensor (1) from the steering knuckle (2).
INSTALLATION PROCEDURE
1. Install the front wheel speed sensor (1) to the steering knuckle (2).
IMPORTANT: Make sure that the front wheel speed sensor (1) is properly aligned and lays flat against the bosses on the knuckle (2).
2. Install the retaining bolt.
^
Tighten the retaining bolt to 8-12 Nm (70.8-106.2 inch lbs.).
3. Connect the front wheel speed sensor electrical connector.
4. Install the Front wheel.
5. Lower the vehicle.
6. Connect the Negative (-) battery cable.
7. Perform the "Diagnostic System Check".
