Metro L3-061 1.0L VIN 6 TBI (1998)
Vacuum Brake Booster: Service and Repair
Vacuum Brake Booster Replacement
REMOVAL PROCEDURE
^
TOOLS REQUIRED
- J 39567 Booster Push Rod Gage
1. Remove the hydraulic modulator/motor pack assembly (if equipped with ABS).
2. Remove the master cylinder.
3. Remove the hose clamp and the hose from the booster (1).
4. Remove the cotter pin (1) and the clevis pin (6) from the push rod clevis (5).
5. Remove the push rod clevis (5) from the brake pedal.
6. Remove the four mounting nuts (2) and the booster assembly from the bulkhead.
NOTICE: Refer to Service Precautions.
7. Measure the push rod clevis length. Install the push rod clevis (2) so that a push rod clevis length ranging from 99.5- 100.5 mm (2.92-3.96 in) is
obtained.
^
Tighten the push rod clevis locknut to 25 Nm (18 ft. lbs.).
