Metro L3-061 1.0L VIN 6 TBI (1998)
A/C Pressure Sensor/Switch - Cooling Fan: Service and Repair
Removal Procedure
1. Gently pull the knobs from the heater control unit.
2. Remove 2 screws in the radio bezel.
3. Remove the 1 screw and the instrument panel cluster right lower cover.
4. Remove the heater control unit from the instrument panel.
5. Disconnect the air conditioning (A/C) switch electrical connector (1).
6. Remove the A/C switch (2) from the heater control unit.
Installation Procedure
1. Install the A/C switch (2) to the heater control unit.
2. Connect the A/C switch electrical connector (1).
3. Install the heater control unit to the instrument panel.
4. Install the heater control unit knobs.
5. Install 2 screws in the radio bezel.
6. Install the instrument panel cluster right lower cover.