Metro L3-061 1.0L VIN 6 TBI (1998)
Brake Light Switch: Adjustments
REMOVAL PROCEDURE
CAUTION: Refer to Fastener Notice in Cautions and Notices.
1. Remove the negative battery cable.
2. Disconnect the stoplamp switch electrical connector.
3. Press the brake pedal.
4. Remove the locknut from the threaded portion (2) of the stoplamp switch (4).
5. Use the following procedure to adjust the stoplamp switch (4):
5.1. Pull the brake pedal all the way back and hold.
5.2. Adjust the switch position so that the switch plunger is pressed by the brake pedal contact plate. Ensure that the threaded portion (2) of
the switch (4) is within 1.5-2.0 mm (0.06-0.08 in) from the pedal contact plate.
INSTALLATION PROCEDURE
NOTICE: Refer to Service Precautions.
1. Press the brake pedal and install the stoplamp switch locknut.
^
Tighten the stoplamp switch locknut to 8 Nm (71 inch lbs.).
2. Connect the stoplamp switch electrical connector.
3. Connect the negative battery cable.
