Metro L3-061 1.0L VIN 6 TBI (1998)
Daytime Running Lamp Control Unit: Service and Repair
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Disconnect the daytime running lamp (DRL) control module electrical connector (1).
3. Remove the following components From the vehicle:
3.1. The mounting screw (3)
3.2. The DRL control module (2)
INSTALLATION PROCEDURE
1. Install the DRL control module (2) to the vehicle. Secure the module with the mounting screw (3).
2. Connect the DRL electrical connector (1).
3. Connect the negative battery cable
