Metro L3-061 1.0L VIN 6 TBI (1998)
Information Bus: Initial Inspection and Diagnostic Overview
PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. If all components are not accessible with a scan tool, check for an open in PPL wire between S249 and DLC-OBD II.
2. If a single component is not accessible with a scan tool, check for an open in PPL or PPL/WHT wire between component and S249. If the wire is
OK, refer to Antilock Brake System for ABS diagnosis and Diagnosis in Supplemental Inflatable Restraint (SIR) System for SIR diagnosis.
See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems See: Restraint Systems/Air Bag Systems
^
Check for an open (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in an continuity/
voltage check with the system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by
monitoring for a voltage drop with the system operational (under load).
^
Check for proper installation of aftermarket electronic equipment which may affect the integrity of other system (Refer to Troubleshooting
Procedures). See: Diagrams/Diagnostic Aids
^
Refer to System Diagnosis.
