Metro L3-061 1.0L VIN 6 TBI (1998)
3. Connect the TP sensor to the TBI unit.
4. Secure the TP sensor to the TBI unit with the two screws, but do not tighten fully.
5. Install a new lower fuel injector insulator into the fuel injector cavity of the TBI unit.
Notice: Do not twist the fuel injector during the installation to the throttle body in order to prevent damage and misalignment of the fuel injector O-ring
seals.
6. Install the fuel injector to the TBI unit.
7. Install the fuel injector cover (1) to the TBI unit (with the electrical connector attached) and secure with the two screws (2).
8. Install the air cleaner bracket to the TBI unit and secure with the two bolts.
Tighten
Tighten the ACL bracket bolt to 10 N.m (7.5 lb ft).