Metro L3-061 1.0L VIN 6 TBI (1998)
Steering Wheel: Service and Repair
Steering Wheel Replacement
^
Tool Required:
- J 1859-A Steering Wheel Puller
REMOVE OR DISCONNECT
1. Disable the Supplemental Inflatable Restraint (SIR).
2. Negative (-) battery cable.
3. Inflator module.
4. Steering wheel retaining nut from shaft.
5. Scribe an alignment mark across the wheel and the steering shaft. This will ease installation.
6. Install the Steering Wheel Puller to the steering wheel and remove wheel from steering shaft.
INSTALL OR CONNECT
NOTE: When installing the steering wheel, the two lugs on the SIR coil must line up with the two grooves on the back side of the steering wheel or
the SIR coil will be damaged when turning the steering wheel.
1. Steering wheel to steering shaft, matching alignment marks on wheel and shaft; secure with steering wheel retaining nut.
^
Tighten steering wheel retaining nut to 33 Nm (24 ft. lbs.).
2. Inflator module.
3. Negative (-) battery cable.
4. Enable the SIR.