Monte Carlo V6-260 4.3L DSL (1983)
Drive/Propeller Shaft: Service and Repair
EXC. 1984---88 CORVETTE
1.
With transmission in neutral and parking brake released, raise and support vehicle.
2.
Mark position of shaft in relation to pinion flange for reassembly.
3.
Remove straps securing universal joint to pinion flange, then disconnect shaft from flange. Tape bearing cups to universal joint to prevent loss
of needle bearings.
4.
Slide yoke out of transmission and remove propeller shaft. Insert suitable plug in transmission to prevent fluid loss.
5.
Reverse procedure to install.
