Monte Carlo V6-3.4L VIN E (2000)
Trunk / Liftgate Weatherstrip: Service and Repair
Rear Compartment Lid Weatherstrip Replacement (Monte Carlo)
Removal Procedure
1. Open the rear compartment.
2. Remove the rear compartment weatherstrip from the pinch-weld flange.
Installation Procedure
1. Align the rear compartment weatherstrip metal joint to the center of the striker on the rear compartment lid.
Important: In order to minimize bulging conditions, avoid stretching the weatherstrip around the corners.
2. Install the rear compartment weatherstrip onto the pinch-weld flange, starting at the top center of the lid opening and working toward the bottom
center. Use a rubber mallet in order to ensure the full engagement of the rear compartment weatherstrip to the pinch-weld flange.
3. Close the rear compartment.