Monte Carlo V6-3.4L VIN E (2000)
Compressor Shaft Seal: Service and Repair
Compressor Shaft Seal Removal (V5 - Conventional Mount)
TOOLS REQUIRED
^
J 34992 Compressor Holding Fixture
^
J 39400-A Electronic Halogen Leak Detector
^
J 9553-01 O-ring Remover
^
J 5403 Snap Ring Pliers
^
J 23128-A Seal Seat Installer and Remover
IMPORTANT: Do not change a shaft seal because of small amounts of oil found on an adjacent surface. The seal allows some oil to pass for
lubrication purposes. Change the shaft seal when the following conditions exist:
^
A large amount of sprayed oil is found.
^
Actual refrigerant leak is found, using a J 39400-A or equivalent.
1. Install the compressor into the J 34992.
2. Remove the clutch plate and hub assembly.
3. Remove the shaft seal retaining ring using the J 5403.
4. In order to prevent dirt or foreign material from damaging the compressor, thoroughly clean the following parts:
^
The inside of the compressor neck area surrounding the shaft
^
The exposed portion of the seal
^
The compressor shaft
^
The O-ring groove
IMPORTANT: Securely hand-tighten the handle of the J 23128-A. Do not use a wrench or pliers.
