Monte Carlo V6-3.4L VIN E (2000)
42.
Select New VIN and press Enter.
43.
Enter the correct VIN.
44.
Press Exit until you are back to the Special Functions screen.
45.
Select BCM Programming and press Enter.
46.
Select Set-Up BCM. Press the key under the highlighted Set-Up BCM on the Tech 2.
47.
The Tech 2 will display the following message: NOW SETTING UP THE NEW BODY CONTROL MODULE.
48.
A Body Control Setup Complete message will appear on the display. Press the key under the highlighted Exit.
49.
Select Set Options and press Enter.
50.
Select Point of Sale and press Enter. The setting options screen will appear again. Press the key under the highlighted Done again.
51.
Select Domestic under Point of Sale. Press the key under the Save option area on the screen.
52.
Select Set Option Configuration and press Enter.
53.
Press the key under the highlighted Done area of the Tech 2 display.
54.
Select the options you recorded from the original BCM in Step 18. Highlight the option by using the arrow keys on the Tech 2. Press Enter to
place an asterisk (*) in front of the option. When all the options have been selected, press the key under the highlighted Save Options area on the
Tech 2.
55.
Exit back to the Main Menu screen.
56.
Remove the Tech 2 from the DLC and the vehicle.
Important:
Perform the following theft deterrent re-learn procedure when one or more of the following conditions has occurred:
^
The BCM has been replaced or reprogrammed (set-up, configured).
^
The ignition key cylinder assembly has been replaced.
57.
You MUST perform the following manual theft deterrent re-learn procedure. The required procedure has a special step that must be completed or
the theft re-learn will not work.
58.
Turn the ignition switch to OFF and wait 15 seconds.
59.
Turn the ignition switch to START. Hold it in this position until the instrument cluster telltale lamps illuminate (approximately seven seconds).
Then release the ignition switch to the RUN position (the engine will not crank).
60.
The Security and Battery messages will begin toggling.
61.
The ignition key must NOT be disturbed for the next 10 minutes. When the 10 minute time period has elapsed, the Security/Battery telltale will
become a solid battery-only lamp.
62.
Turn the ignition to OFF. With the PRNDL display off, wait five seconds.
63.
Turn the ignition switch to START and hold it in this position until the instrument cluster telltales illuminate (approximately seven seconds). Then
release the ignition switch to the RUN position (the engine will not crank).
64.
The Security and Battery messages will begin toggling.
65.
The ignition key must NOT be disturbed for the next 10 minutes. When the 10 minute time period has elapsed, the Security/Battery telltale will
become a solid battery-only lamp.
66.
Turn the ignition to OFF. With the PRNDL display off, wait five seconds.
67.
Turn the ignition switch to START and hold it in this position until the instrument cluster telltales illuminate (approximately seven seconds). Then
