Monte Carlo V6-3.8L SC VIN 1 (2004)
Speaker: Service and Repair
Speaker Replacement - Front Door
SPEAKER REPLACEMENT - FRONT DOOR
REMOVAL PROCEDURE
1. Remove the front door trim panel.
2. Remove the door speaker screws.
3. Pull the speaker towards you. Disconnect the electrical connector from the speaker.
4. Remove the speaker.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the speaker. Position the speaker to the door.
2. Install the speaker.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the speaker screws.
Tighten
Tighten the speaker screws to 2 N.m (18 lb in).
IMPORTANT: Due to the lower trim fasteners close proximity to the speaker cone, the door trim must be installed with care.
4. Install the front door trim panel.