Monte Carlo V6-3.8L SC VIN 1 (2004)
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the Sunroof opening Position Switch screw (2) to the switch.
Tighten
Tighten the SOPS screw to 2 N.m (18 lb in).
3. Connect the electrical connector to the SOPS.
4. Install the sunroof actuator.
5. Remove the position lock pin (1) or the 2 wires from the switch.
6. Remove the 2 pins from the cable/cam mechanisms.
7. Install the left and right front sunroof window panel screws.
Tighten
Tighten the front sunroof window panel screws to 4 N.m (35 lb in).
8. Install the sunroof module, but do not install the headliner until after you have tested the sunroof operation.
9. Inspect the operation of the sunroof.
10. Install the headliner.
