Monte Carlo V6-3.8L SC VIN 1 (2004)
Sunroof / Moonroof Wiring Harness: Service and Repair
SUNROOF WIRING HARNESS REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT: Note the following locations:
-
The position of the wire harness routing
-
The location of the tie-straps that secure the harness to the drive cable tubes and the sunroof express module
1. Position the sunshade in the full forward position.
2. Remove the headliner.
3. Remove the rear shelf.
4. Cut the nylon tie straps on the express module and the drive cable tube.
5. Disconnect the electrical connector from the following components:
-
The sunroof express module
-
The sunroof actuator
-
The Position Encoding Switch
6. Remove the tape holding the wire harness to the module.
7. Remove the wire harness from the sunroof.
INSTALLATION PROCEDURE