Monte Carlo V6-3.8L SC VIN 1 (2004)
Seat Cushion: Removal and Replacement
Seat Cushion Cover Replacement - Front (Bucket Seat)
Seat Cushion Cover Replacement - Front (Bucket Seat)
Removal Procedure
1. Remove the front seat from the vehicle.
2. Remove the front seat trim panel.
4. Disconnect the electrical connector for the heated seat, if equipped.
5. Unfasten the J-hook retainers on all sides of the front seat cushion cover.
6. Unfasten the side J-hook retainers located at the seat back.
7. Fold the seat back down to a horizontal position.
8. Unfasten the hook and the loop retainers securing the seat cushion cover to the cushion.
9. If the vehicle is equipped with heated seats, pull the seat heater electric line up through the foam cushion.
10. Pull the trim and cushion foam from under the seat back.
