Monte Carlo V6-3.8L SC VIN 1 (2004)
Seat Heater Switch: Procedures
HEATED SEAT SWITCH REPLACEMENT - FRONT (MONTE CARLO)
REMOVAL PROCEDURE
1. Remove the front floor console trim plate.
2. Disconnect the electrical connector from the front floor console wiring harness.
3. Remove the front seat heated seat switch, using a small, flat-bladed tool to release the retainer clips.
4. Remove the front seat heated seat switch from the front floor console trim plate.
INSTALLATION PROCEDURE
1. Install the front seat heated seat switch to the front floor console trim plate, pressing into place until fully seated.
2. Connect the electrical connector to the front floor console wiring harness.
3. Install the front floor console trim plate.
