Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Lubricate the following parts with the silicone grease that is supplied in the repair kit:
^
O-rings (5)
^
Proportioning valve seals (4)
^
Proportioning valve piston stems (3)
2. Install new seals on the proportioning valve pistons. Ensure that the lip seals face up toward the cap.
3. Install the proportioning valve pistons and the seals in the master cylinder body.
4. Install the springs (2) in the master cylinder body.
5. Install new O-rings (5) in the grooves in the proportioning valve caps.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the proportioning valve caps (1) in the master cylinder body.
^
Tighten the proportioning valve caps to 27 Nm (20 ft. lbs.).
7. Install the bracket (1) to the master cylinder.
8. Install the master cylinder reservoir.
9. Bleed the brakes.
